Height selector is unusable when meteogram and expert mode is shown
-
When meteogram/airgram and expertmode is on, Height selector is shrinked so it is impossible to select height. Only Surface or highest FL is possible to select.
Moving height selector to the left of layer bar is one of the possible fixes.
-
@ondrejspilka723 Hi, we are aware of this issue and colleagues will take a look at this. For now, I would recommend closing the meteogram to handle this change, since there is no visible change there with moving the slider.
-
In addition if you need to show at same time the Meteograms and the map at different levels (which for me is of little interest) you can first set the level for the map with the Altitude slider and then open the Meteogram.
Personally I would not like to have the Altitude slider at left of the layer list which would reduce the space for the map. -
@idefix37 Meteogram always shows 1000hPa wind.
See my other recent report.
-
@idefix37 well depends on resolution/form factor for sure.
On PC with wide screen I assume it will be fine, but up to you guys. -
@Ondřej-Šutera Thanks, appreciate.
-
@ondrejspilka723
Meteogram shows wind at ground surface.
Why do you set the Altitude slider at 3000m in your screenshot ?EDIT: I see you posted several topic about the same question.
Please don’t multiply them ! -
@idefix37 yes I added the same comment when I realized it is worth of report. Sorry for any confusion.
Why is meteogram showing wind at 1000hPa? It just doesn't make sense since main location entry point is map with surface. Location shows altitude. User wants to see wind at location thus at altitude.
I could understand wind respects height slider, but that's not the case either.
-
@idefix37 and why I setup slider? To see real wind in 2700 AMSL.
What do you mean by ground surface? AMSL or altitude of location?
-
@ondrejspilka723
Meteogram does not show the wind at 1000 hPa level, but at the location elevation that is the altitude amsl. -
@Ondřej-Šutera Wind at 10K ft has become unusable, and the slider is too sensitive.
-
@JD-Nichols Hello, to use the slider, you need to close the detailed forecast.
Korina
-
@JD-Nichols Thank You!
-
@Korina Closed detail forecast did not change slider sensitivity. 10K ft used to be available on the slider - no longer and it has become too sensitive to be useful. Please change it back to what it was a few weeks ago.
-
@JD-Nichols Can you please send the screenshot of the issue? If you have small height bar, you can change your list of layers in the expert mode as well.
-
Slider very small and sensitive....surface and FL450...
-
@JD-Nichols What device do you use? Can you specify the model?
-
@Ondřej-Šutera HP laptop.
-
@JD-Nichols Can you please specify the resolution of the device? This can be related to lower resolution of the screen. I see this with the same setup as you have:
-
@Ondřej-Šutera This used to work very well(no change in computer resolution) - it changed about a month ago and has made it VERY difficult to use. I use 10K winds for flying a light plane around the cascade mountains...and the winds at this level are critical to predict turbulence and flying conditions. This option is no longer available - sfc, 2500, 6400, FL180, FL450 are helpful but frequently not enough. Thanks.
