Report your Weather Station Data to Windy
-
@gobris Hello, I can see you are already posting some data (wind) and the station appeared on the map. Are you sending any other data?
-
Tom helped me out and the developers had me put double quotes around the entire URL, e.g., curl "https://......". That fixed it. The "&" separating parameters was causing problems without the quotes so only the first parameter was being seen.
Regards.
Greg
-
so far, every post I sent appears.
Working without any issues..
Sending Gust, wind(ms) and temperature at the moment..
-
Hi all. I have setup a webhook for my Photon and all seems fine from the back-end. howerver i am receiving the following. Just sending temp and humidity to test before adding all sensors.
SUCCESS (valid measurements count: 2, valid station info count: 0)
NOTICE: Measurements not inserted to database because cooldown time 4 minutes (time since previous insertion is 2.16 minutes)!
-
This post is deleted!
-
@jakesie1309 Hello, please send me your station ID. Thank you.
-
Have a PWS on Weatherunderground. Where do I upload my API key to my created station on Windy to upload the data? So lost with the instructions.
-
@mzolna Hello, what type of PWS and software do you have please?
-
Hi all,
I'm pushing data of my Davis Vantage Vue with weatherlink live to CWOP. Data are updated and visible on CWOP but I don't see the station appearing on Windy. The station id is CWOP FW7690
Any other methods to push data on Windy directly from Davis weatherlink live without any additional hardware?
thanks
Luca
-
@iz5axt Hi, you will need to get one of these softwares to actually send data to WIndy:
- Cumulus MX
- Meteobridge
- Weather-Display
- WeeWx
-
This post is deleted!
-
I've tried to upload my PWS data to Windy. Windy is receiving the data, see here:
https://www.windy.com/station/pws-f07cdffb?51.470,-3.146,11,i:pressure
Station ID: ID: f07cdffb
However I can't see my wether station on the map when I click on the wind sock icon. Any ideas? I've tried deleting and readding the station, tried changing the API key.
How long until my PWS will appear on the Windy map? Is there a problem as there's a weather cam at the same location (I also run a weather camera) or is it because the reported values are outside of what is acceptable? or is it because the timestamp on the weather data is out of date perhaps (if there is one); can't think of other reasons....
This is using Meteobridge (which confirms data is being send properly).
I really can't work it out. I'd be grateful for any help.
Thanks,
Alex.
-
@alexjkennedy said in Report your Weather Station Data to Windy:
f07cdffb
Hello, the PWS symbol on the map is already visible, if you switch to Reported temp. layer, you can see your station.
-
Ah thanks. I think it just took a while to appear as it was appearing on the next morning. Thanks for your help.
